Garage Door Repair Services › Broken Spring Repair
Broken Spring Repair in Arlington, TX
When a spring breaks, the door goes from working normally to completely stuck — sometimes in the middle of the night or right before work. The door isn't safe to force open manually, and the opener can't move it without risking damage to the motor. Getting back in requires a tech who can safely release the tension, get the door moving, and install the correct replacement spring.
Arlington Garage Door Pros provides broken spring repair for homeowners across Arlington, TX. Call for a free inspection and a written quote before any work begins.
When to Call
When You Need Broken Spring Repair
- You heard a loud bang and now the door won't lift more than a few inches.
- The opener runs but the door barely moves and the opener sounds strained.
- You can see the coil spring above the door has a visible gap or separation.
- Your car is stuck inside and you need to get it out before work.
- The door feels extremely heavy when you try to lift it manually.
- One side of the door dropped and is now lower than the other at rest.
How It Works
Our Process for Broken Spring Repair
- 1
Confirm which spring failed and why
Torsion springs sit on a shaft above the door. Extension springs run along the tracks on each side. We identify which type broke and inspect for secondary damage to cables or drums.
- 2
Manual release to access the vehicle if needed
If a car is trapped inside, we can safely manually release the door enough to get it open before completing the repair. We don't make you wait through the full job to get your car out.
- 3
Safely release remaining spring tension
A broken spring often still holds partial tension. This is the step that injures people who attempt DIY repairs. We use proper winding bars and secure the door before removing hardware.
- 4
Assess cables, drums, and bearing plates
Broken springs frequently damage cables when they snap. We inspect the full spring system — not just the broken coil — before installing new hardware.
- 5
Install replacement spring to correct spec
We match the spring to the door's actual weight and height. The wrong spring winds up failing sooner or making the door operate unsafely. Cycle rating matters for longevity.
- 6
Test balance and reconnect the opener
We test door balance by hand before reconnecting the opener. Then we run full cycles and check that the opener isn't working harder than it should under the new spring tension.
What's included
- Safe release of remaining tension before any hardware is removed.
- Replacement spring correctly sized for your door's weight and dimensions.
- Inspection of cables and drums — both sides, not just where the break occurred.
- Manual balance test before the opener is reconnected.
- Full operational test with the opener running through complete open and close cycles.
What's not included
- Cable replacement if they were damaged by the snap — flagged and quoted separately.
- Opener repair or replacement if the motor was stressed from running against the broken spring.
- Any structural repairs to the door opening if the door shifted and damaged the frame.
Real Situations
Common Scenarios in Arlington
A homeowner in east Arlington had a spring snap at 6 a.m. with both cars stuck in the garage.
We manually release the door first to get both vehicles out, then complete the spring replacement with the door in accessible position. We sequence the work around what the homeowner needs most urgently.
A homeowner noticed one spring broke but the other looks intact and wants to know if both need replacing.
Springs wear at roughly the same rate since they cycle together. We measure the remaining spring and assess its condition honestly. Replacing both at once is usually the right call — we explain the reasoning and let the homeowner decide.
A homeowner in an older Arlington neighborhood has extension springs and one snapped, pulling the safety cable loose.
Extension springs use a safety cable threaded through the coil to contain the spring if it breaks. If that cable came loose, we reinstall it correctly before putting tension on the new spring. Skipping this step is a safety hazard.
Arlington Context
Why this matters in Arlington
Arlington's clay soil shifts seasonally, which gradually changes the levelness of garage floors and door frames. That misalignment puts uneven stress on springs, causing one to fail before the other even when both were installed at the same time. The wide temperature range here — from freezing winters to sustained summer heat — also works metal through expansion and contraction cycles that shorten spring life compared to milder climates.
Straight Talk
About pricing & scope
The scope of a broken spring repair depends on what else was damaged when it snapped — cables and drums are the most common secondary damage. We assess everything before quoting the full job. Doors that haven't been serviced in years often have worn rollers or frayed cables that make sense to address while the door is already down.
What This Fixes
Problems We See in Arlington
More Garage Door Repair Services
Broken Spring Repair Near You